Cannot Start Labour as Approval Is Pending.

At the time of Starting Labour Status in Repair Order document if user face below validation (Snap 1), then user will have to click on Confirm RO Button available on General Page as shown in Snap 2.

Snap 1

Snap 2

• Related Articles

• How to delete Sublet labour.

  As per the present DMS lite functionality, once the Sublet order is created the same labour cannot be deleted in Repair order document. But user can provide 100% discount to the wrongly selected sublet labour Or cancel the existing RO and create a ...

• You cannot set "Ready For Invoice" since one or more 'Service/Part' is pending.

  Validation Snap 1 : The DMS lite system will be giving such validations to the user, if there's any Part Qty is not issued, or the Labour Status is not completed for a Labour as shown in attached snap. Resolution :- Step 1 : User must ensure that all ...

• Qty column is missing for Labour field in Repair Order.

  As per the present DMS lite configuration, quantity column is not available for the labor field in RO/BRO. Additionally, the labours are configured as per the data provided by the Ford and get calculated on the basis of FRH.

• FSA Part and labour amount is showing on Pre-invoice copy.

  For Parts issued under FSA repair type, dealer user will have to create Ratio Billing under dealer expenses. Once the ratio billing is done under dealer expenses, the amount for those parts will be showing zero in pre-invoice document

• In service estimate separate parts and labours details required

  New DMS prints for parts and labour are aligned according to customer verbatim to better explain customer on billing of parts & labour binned against which guest complaint. If any issues found on numbers/values – then support desk can investigate and ...